Name:
name must be entered to submit this form

Organisation:

email:
valid email address must be entered to submit this form

Product Description:
What type of substrate do you want to place

How will it be presented to the pick and place magazine

What orientation does the product need to be placed
(cavity up, cavity down, short edge leading, long edge leading etc.)

Product Dimensions
Range of product sizes

Dimensions of each product to be placed
(Width/Height/Depth)

Placements per minute required for each tray size

Desired Placement
Onto, into, on top of, next to, before target, after target

Placement Target
Conveyor, carton, bottle, case,

If target is a product, dimensions of the product for each size
(Width/Height/Depth)

Conveyor Belt
Height

Width: (reach from side of machine to placement area.)

Type of conveyor:
flighted, flat belt, interlocking etc

Does it have guide rails to ensure accurate placement?

Motor type:
stepping motor or continuous

Lineal speed of the line
How fast is the conveyor traveling when placement occurs?

Placements pm. required for each product size

Operating environment
Where is the machine going to operate?
Coolroom, Hot area, dusty environment, wet area

Type of construction
Standard
Painted Steel construction of frame and stainless magazines

Washdown:
Stainless steel construction opf frame and stainless magazines, fully enclosed electrical enclosure to IP 65 standards or higher

Vacuum Pump
Venturi
Vacuum pump

Signalling
PLC requirements (Allen Bradley preferred)

Where is the start/stop signal originating from: (from sensor on line or parent machine)

Down stream sensor (to tell our machine when the line if full)

Stop signal if emergency stop signal from parent machine

Additional positions required on the I/O board

Once we have this information we will have a better understanding our your application and can then formulate a quotation, we would also like to see some digital pictures of the line you wish to put our machine on and if practible a site visit may be necessary. We also require product samples of items to be placed as well as the target products.

Tray Denesting
Please download our blister and tray specification sheet, to understand our requirements to automatically denest products. [Click here to down load the pdf].